PH8 stops responding | Thales IoT Developer Community
June 9, 2015 - 9:44am, 1695 views
Testing out a new board using a PH8. Connected via serial at 57600 after disabling USB using AT^SDPORT=2.
Found that if I reset the device several ***** in quick succession by pulling down EMERG_OFF then IGT, device seems to shut down and stops responding. PWR_IND signal turns on when IGT activated but then turns off few seconds and stays off. Also get several screens of random characters come out on terminal connected to device. Tried same with EU3 modem and that doesn't do the same thing.
HI,
Please, try to change the baudrate od frame of the serial port in your aplication to 115200-8-N-1-None in the case of PH8
Regards
ALopez
Somewhere over the rainbow!!! Looking for the Oz Land!!!