No output of NEMA sentences with PLS8-E | Thales IoT Developer Community
August 15, 2019 - 3:00pm, 828 views
i have an embedded linux device using a PLS8-E ****m for LTE and GPS. LTE works fine, but I cannot seem to get anything out of the GNSS tty.
I have enabled the NEMA output following the description in the AT command reference document (the one for non aided **** for now). I use the service set 2. The current state of the GNSS is as follows:
This seems to look fine to me. I tried to get any output on /dev/ttyACM2 using microcom but I got nothing. I have tried various bit rates as I have not found any information on the bit rate that is used for /dev/ttyACM2.
I would appreciate any hints that would allow me to proceed here. Thank you very much.
PS: I was also wondering what the NEMA output would look like if I have no reception. Does it report in intervals that it does not have a fix?