Gemalto is now part of the Thales Group, find out more.

You are here

Community > Forum > Cellular Hardware > BGS5 ATEvent listner for recived SMS

BGS5 ATEvent listner for recived SMS | Thales IoT Developer Community

Like
0
3
Jure's picture
Jure

September 18, 2014 - 1:24pm, 3682 views

I had a working application, for reciving and reading SMS in Java (I use Gemalto example code). But sudenly application stoped working. ATEvent listener won't triger anymore on recived SMS, but if I check in terminal with at+cmgl I can see all unread SMS. I tryed changing AT+CNMI, but that didn't help so I also tryed reseting all the settings with AT&F, which also doesn't help. Do you have any advice what should I do? I also have deleted old SMSs. Thank you for your help.
3
Comment
Log in or register to post comments
Jure's picture
Jure
Sep 18 2014 - 7:11pm
I don't know if it's conneted with this problem, but inside terminal (USB or Serial connection) I can't issue commands like: -at^spio=1 -AT^SRADC -AT^SSPI= ... I allways get CME ERROR: Unknown -AT^SCFG="URC/Ringline","local","2" or any similiar config returns: +CME ERROR: invalid index and when i enter AT^SCFG=?, there is no information about ringline. But I can get value of GPIOs and set there values trough Java program without problem. Also from yestrday at module startup I allways get ^SYSINFO: 200 after +PBREADY, which I don't remember that would be showing before. EDIT: I checked for ^SYSINFO: 200 and that it probably because I have 1 midlet set to autostart, but autostart is disabled.
Jędrzej Gemalto Moderator's picture
Jędrzej Gemalto...
Sep 18 2014 - 6:57pm
Hi, Regarding no SMS URCs - please notice that AT+CNMI setting is interface specific. You need to set it on the same interface to which ATListener is binded. Please also note that if you're using Phase 2+ messages should be acked wth AT+CNMA or CNMI <mt> passes to 0 which disables further URCs. Regarding non-working commands: some part of midlet functionality is implemented in JRC Java MIDlet (e.g. the commands you've listed). As JRC is integral part of module's firmware it's suggested to keep userware autostart enabled. Regards Jedrzej
Jure's picture
Jure
Sep 18 2014 - 7:48pm
It looks that it was disabled autosatart that was causing problmes for everything. Now I can use all AT commands and UCR's work. Thank you for you help.