BGS5 terminal hangs on serial interface | Thales IoT Developer Community
September 3, 2014 - 4:42pm, 2544 views
Hallo,
now i have the second fresh neu BGS5 terminal.
^SYSSTART
ati1
Cinterion
BGS5
REVISION 01.100
A-REVISION 00.000.02
I go to COM1 with Putty 115200,8,'N',1
After may be 30 s CTS line goes down and and it's impossible to enter any AT Command.
CTS-Line now Flashes every 2 s from 0 to 1 and back.
How can do a "full factory" reset ?
Where is the dokumentation about the hardware watchdog of the termainal ...
Sep 4 2014 - 1:51pm
Hello,
probably power saving on serial is enabled. Please set AT^SPOW=1,0,0 to disable it.
It is not possible to restore all parameters to factory settings. Some of them are restorable with AT&F. Find the list in chapter 21.6 "Factory Default Settings Restorable with AT&F" of AT spec.
Regards
Jedrzej
- Log in or register to post comments