DTMF Decoding | Thales IoT Developer Community
May 10, 2016 - 3:57pm, 3425 views
I try to decode DTMF signals on a Cinterion PH8-P ****m during a voice call:
1.Enable event reporting:
2. Doing a MO voice call
3. Sending DTMF signals from the called phone/****m
In the standard audio **** detection rate is poor. When I switch to audio **** 6 via
detection rate becomes much better. Are there other audio settings which can have effects on DTMF decoding?
Thanks in advance,
Generally the DTMF tones are transferred as voice so the quality of the connection matters.
With the SNFS command you choose the preset audio configuration. Each **** is optimized for certain usage. The documentation recommends using **** 6 for DTMF detection so it should be the best choice. Of course you can change the preconfigured parameters manually for fine tuning.
thanks for your comment.
After power up audio **** is 1 (this is also mentioned in the ****m's doc):
Welcome to minicom 2.6.2
Compiled on Apr 26 2016, 15:37:23.
Port /dev/ttyACM0, 08:08:24
Press CTRL-A Z for help on special keys
Are there any additional informations (beside the ****m's doc) at Gemalto about DTMF handling/tuning?
There's no dedicated document for DTMF decoding. There is only a document describing audio interface. You could probably request it from your module supplier. As audio **** 6 is recommended for DTMF detection I suppose it's settings are optimal for that. So if the detection rate is not satisfactory you could experiment with modifying the settings and check by your own if it can change anything in your particular case.
But if some tones are not recognized maybe the signal quality is very low or changing SIND parameters for DTMF could help or sending longer tones.
the quality of the DTMF tones also depends of the audio codec negociated with the netwrok for voice calls.
Check the documentation of the module your are using , in order to disable the audio codecs with low bitrates.
are you sending the DTMF codes with a external DTMF generator, or just using AT commands. In the second case the AT command requests to the network to reproduce the DTMF in the target. That's the network generates the DTMF code
Somewhere over the rainbow!!! Looking for the Oz Land!!!