Gemalto is now part of the Thales Group, find out more.

You are here

EHS5T Terminal RS485 minimum baud rate | Thales IoT Developer Community

September 26, 2019 - 2:39pm, 1380 views


When I try to open RS485 port of EHS5T terminal with 300 baud, 7 data bits, 1 stop bit, Even parity, I get error. (The reason I use 300 baud is that the IEC62056-21 protocol starts communicating at this baud rate).

I have read 1200 bauds of the lowest baudrate supported in the documents.

I think this only applies to terminals.

Normally, the UART of the EHS5 module can be switched to 300 baud.

Is there a chance that I can open the RS485 port of the EHS5T with 300 baud?

Thank you.