Enable hardware watchdog remotely/i2c | Thales IoT Developer Community
January 4, 2017 - 4:06pm, 2311 views
In the datasheet I understand that it is possible to configure the hardware watchdog via i2c however I only see that the GPIO direction can be configured this way. Is there a way to configure options like "WD_ALWAYS_ON", or enable "WD=RST_GPIO,600000,6" via I2C?
We have a few modules in remote locations that seem to be shutting down for no reason and never waking up. Is it possible to configure the hardware watchdog via I2C from within Java? I was thinking about writing a midlet that simply activate the hardware watchdog. In the datasheet I only see the options for configuring the GPIO via I2C watchdog.
You can find a nice article about the wacthdog and a java example in the forum
Somewhere over the rainbow!!! Looking for the Oz Land!!!
The complete configuration of the watchdog is only possible via ASC0 line unfortunately.