Program for SSPI configuration of GPIO's | Thales IoT Developer Community
January 21, 2015 - 4:39pm, 2411 views
Because if you want to use your GPIO's on BGS5t and probably on other terminals, you need to configure them trough SSPI command, I created a small Java program where you can do that trough GUI.
It's quite simple program where you set GPIOs trough checkboxes, select COM port and click confirm button. At the end terminal will shutdown.
Program was just tested on BGS5t.
Disclaimer: I assume no responsibility for any loss or hardshipincurred directly or indirectly by using this program.
Download: https://drive.google.com/file/d/0B4p4jh0vfEBPQndhSXlpR0FSWVU/view?usp=sh...
Hi Jure,
Thank you for the nice application! I tested that for an EHS6T USB Release 3 A-revision 14 and it is
working fine.
It would be nice if Gemalto could make a similar tool for us, including all I/O, watchdog and later the LAN.
Antero Markkula
Communication and Mechatronics
Enkom Active Oy – www.enkom-active.fi
Upseerinkatu 3 A, 02600 Espoo, Finland
Mobile: +358 400 411368
Office: +358 10 204 0000
Fax: +358 10 204 0010
E-mail: antero.markkula@enkom-active.fi