Using values from commands into Midlet | Thales IoT Developer Community
November 30, 2016 - 10:35am, 2803 views
In our Midlet we need to check the signal quality just after the starting to can be sure that our files could be copied into Module.
As I undertand in order to know the signal quality are two commands: AT+SCQ and AT^SMONI. For conections with 3G is recomended to use AT^SMONI.
According to this discussion in the forum the conditions to begin the transfer are:
values RSCP > -100 dBm and Ec/No > -14 dBm can be considered like the acceptable conditions
Values RSCP > - 47 and Ec/No > -4 dBm can be considered like optimal conditions
private ATCommand atc;
private String check_Quality ="";
I'm getting the signal quality answer:
and I would like to use these values" -12.0 ( Ec/n0),-89 (RSCP) "in my Java code. To can do something like:
if (Ec/n0 && RSCP are good enough) SHOW signal is good enough, ready to download
So my question, how is posible to obtain precisely this values and use them inside the code?
I also notified that in SL Portal, on network tab, Signal (RSCP) and RSSI are in diferents positions, so seems to me that ***** to be a way to can use this values.